威尼斯城所有登入网址-首页

Welcome to 威尼斯城所有登入网址 Website
Contact Us???
Your Position: Home > Support

How to deal with the noise during the operation of the dryer equipment

2016/8/30??????view:
Heat pump drying machine operation noise is inevitable, but the noise is too large to pay attention to, we can not make the heat pump dryer noise disappeared, only to maximize the noise reduction.
The following heat pump dryer to help you solve the problem of dryer noise. There are too many small parts, compressor, burner, mixer and so on in the dryer, which is the main source of noise. The general reason for the noise of the dryer is:
1, heat pump drying machine installation is not stable, the workpiece placement is not uniform.
2, heat pump drying machine in the operation of the bearing is not timely refueling or damaged.
3, heat pump dryer in the operation of the fixed bolt bearing seat.
According to the analysis of the above reasons, the solution to the noise of the dryer is as follows:
1, re install the dryer equipment, the bearing seat fixed bolt solid, replace the dryer equipment damaged bearings.
2, the greater part of the dryer noise with sound insulation cover separate isolation. The sound insulation cover of the drying machine adopts the steel structure skeleton, and the shell is made of a thin steel plate, and the inner layer of the damping layer and the fine glass wool or other sound absorbing materials are filled with the damping layer. As a result of the drying machine running a lot of heat, it must be covered with a certain hole cooling and convenient equipment maintenance and other matters.
3, instead of the original rubber drying machine manganese steel lining, greatly reduce the noise intensity of penetration.
4, between the inner surface of the heat pump dryer cylinder liners and spread heat resistant soft rubber pad or industrial felt to reduce material impact noise.
5, in the heat pump dryer cylinder and other noise sources outside the sound insulation layer.
Heat pump dryer through years of production and sales experience, summed up how to reduce the noise generated by the dryer?
A muffler installed in the equipment installed around the sound absorption screen, as well as in the fan and the sound insulation cover or the construction of the air outlet to reduce noise in the pit to reduce noise.
Two, install the isolation device based on a damping groove or around the ditch, the base isolation device with spring, cork and rubber elastic material. This will also reduce the noise effectively.
Three, sealing insulation: the steel structure skeleton, steel shell, which apply damping layer and filled with superfine glass wool or other sound-absorbing material to the drying machine is closed, but note that higher barrel temperature in the drying process, the need to pay attention to the problem of heat radiation. To carry out scientific and orderly process planning, must not be blind to transform, because the temperature is too high heat dissipation and burned the wind turbine.
Four, maintenance equipment parts: equipment in operation after a period of time, will be shaking, lack of basic equipment, bearing wear or oil fastener looseness, once the above fault, should be timely maintenance for solid infrastructure work, replacement of bearings or lubrication, fastening loose parts etc..

威尼斯城所有登入网址|威尼斯正规官网

XML 地图 | Sitemap 地图